Introduction:

Lambo doors, also known as scissor or vertical doors, are a stylish and unique modification for your car. These doors open upwards rather than swinging outwards, giving your vehicle a distinctive, head-turning look. In this article, we’ll guide you through the process of installing Lambo doors in 13 detailed steps.

Step 1: Vehicle Preparation

Make sure you have a clean and clutter-free work area and park your car on a flat surface. Put the transmission in ‘park’ mode and engage the handbrake. Disconnect the battery terminals to avoid any electrical issues during installation.

Step 2: Gather Tools and Materials

You will need a Lambo door kit specific to your vehicle model, which should include door hinges, gas shocks, and all necessary hardware. Additionally, gather basic hand tools such as wrenches, socket set, pliers, screwdrivers, drill and drill bits, tape measure, marker or pen, and a jack stand or blocks.

Step 3: Remove Door Panels

Start by removing the interior door panels from both doors. Be cautious while removing clips and screws to avoid damaging the panels or electrical components.

Step 4: Disconnect Electricals

Carefully disconnect all electrical components within the door, including power windows and locks, lights or speakers.

Step 5: Support the Door

To prevent the door from falling during installation, use a jack stand or block underneath. Make sure it’s stable and secure before proceeding.

Step 6: Remove Stock Hinges

Loosen and remove the bolts connecting the stock hinges to the vehicle’s frame and door. Keep them along with any shims or spacers for future reference.

Step 7: Mark Drilling Locations

Hold up your new Lambo hinge assembly next to where you removed old hinges. Using a marker or pen, mark drilling locations on the door and vehicle frame.

Step 8: Drill Holes

Carefully drill holes at marked locations. Make sure to use a proper drill bit size based on the Lambo door kit instructions.

Step 9: Attach New Hinges

Bolt the Lambo door hinges onto the vehicle frame and door. Replace any shims or spacers accordingly.

Step 10: Install Gas Shocks

Attach gas shocks provided in the Lambo door kit to both the new hinges and the door frame. They will help provide support and lifting force for your vertical doors.

Step 11: Test Door Movement

Ensure your doors open and close smoothly without hitting any part of your car’s body or other components. Carefully check for clearance when raising doors upward. Adjust hinges as needed to achieve a perfect fit.

Step 12: Reconnect Electricals

Reinstall all electrical components previously disconnected, such as power windows, locks, lights, and speakers.

Step 13: Reattach Door Panels

Finally, install the interior door panels back onto your vehicle’s doors. With this done, you are ready to show off your freshly installed Lambo doors!

Conclusion:

Installing Lambo doors might seem like a daunting task, but with careful planning and attention to detail, it’s an achievable DIY project that adds some serious visual impact to your car. Always follow manufacturer instructions when using Lambo door kits and consult a professional if you run into issues or are unsure about any step of the process. Good luck, and enjoy turning heads with your stylish new Lambo doors!