Introduction:

Cutting coil springs is a popular and cost-effective method for lowering a vehicle, which can improve its aesthetics and handling. In this article, we will walk you through the process step-by-step.

Step 1: Gather tools and materials

To get started, you’ll need the following items:

– Safety glasses

– Jack stands

– Floor jack

– Cutting torch or angle grinder

– Measuring tape

– Chalk or marker

– Protective gloves

Step 2: Consult your vehicle’s manual

Before making any modifications to your car, read through its manual to learn the recommended height and spring rate for your specific make and model.

Step 3: Park on a flat surface

Make sure to park your car on a level surface. This ensures accurate measurements before and after cutting the coil springs.

Step 4: Measure wheel gap

Measure the distance between the top of the tire and fender well with your measuring tape. Record this measurement for future reference.

Step 5: Jack up your vehicle

Using a floor jack, lift your vehicle high enough to place jack stands under its frame. Ensure that the car is stable and secure on the stands.

Step 6: Remove wheels and tires

Once safely supported by jack stands, remove your car’s wheels and tires.

Step 7: Remove coil springs

Follow your vehicle manual’s instructions for removing coil springs from their mounts. Typically, this involves loosening and removing any hardware securing them in place.

Step 8: Mark sections to be cut

Once removed, use a measuring tape and chalk or marker to mark where you want to cut off sections of the coil. Keep in mind that less spring means more stiffness, so avoid cutting too much at once.

Step 9: Cut the coil springs

Put on safety glasses and gloves before beginning this step. Carefully cut the marked sections using a cutting torch or angle grinder. Be sure to cut slowly and evenly to avoid damage to the coils.

Step 10: Reinstall the cut coil springs

Place the modified coil springs back into their mounts, following your vehicle’s manual for proper installation.

Step 11: Reassemble wheels and lower vehicle

Reassemble the wheels onto your car, then carefully lower it off the jack stands. Check the wheel gap measurement again and confirm that you’ve achieved your desired height. If necessary, adjust the cut springs further to ensure an even drop.

Conclusion:

This step-by-step guide should help you successfully lower your vehicle by cutting its coil springs. Always exercise caution and wear proper safety gear when undertaking such tasks. Happy modding!