3 Ways to Clear Clogged Windshield Washers
A clogged windshield washer can be quite inconvenient and even dangerous when driving in harsh conditions. Dirt, debris, or a frozen washer fluid line can cause blockages in the system, affecting your vehicle’s functionality and safety. In this article, we will explore three effective methods to clear clogged windshield washers and restore their performance.
1. Inspect the Nozzles
Clogged nozzles are a common cause of windshield washer problems. Follow these steps to inspect and clean the nozzles:
– Locate the nozzles on the hood or wipers of your car.
– Use a small needle or pin to gently probe the nozzle holes, dislodging any visible dirt or debris.
– Spray pressurized air (from a can of compressed air or an air compressor) into the nozzle to remove stubborn particles.
– Test the washers by activating them with the car’s controls. If they spray well-adjusted jets of fluid, you’ve successfully cleared the clogs.
2. Check and Flush the Washer Fluid Reservoir
If cleaning the nozzles doesn’t solve the issue, there might be contamination or sediment accumulating in the washer fluid reservoir. Follow these steps to clean it:
– Locate the washer fluid reservoir under your vehicle’s hood, usually marked with an icon resembling a windshield.
– Drain any remaining fluid from the reservoir using a siphon pump or by disconnecting its hose.
– Fill the reservoir with a mixture of water and mild soap, then reconnect everything.
– Activate the washers several times to flush out contaminants in both reservoir and lines.
– Drain the soapy water from the reservoir before refilling it with fresh washer fluid.
3. Thaw Frozen Washer Lines
In colder climates, freezing temperatures can turn washer fluid within hoses into ice, impeding its flow. Here’s how to thaw and prevent freezing in washer lines:
– Park your vehicle in a warm area, like a garage, to allow the ice in the lines to melt naturally.
– If you need a faster solution, use a portable heater or hairdryer to apply gentle heat around the reservoir, hoses, and nozzles. Be cautious not to overheat or damage any components.
– When refilling the washer fluid reservoir, always choose a fluid with a lower freezing point than your area’s lowest temperatures.
In conclusion, addressing clogged windshield washers can be accomplished by inspecting and cleaning nozzles, flushing the washer fluid reservoir, and thawing frozen lines. Regularly checking and maintaining your windshield washer system is crucial for optimal visibility and safety while driving.